Living Screen

by Irina Shaklova
09 Aug 2015 / 4450 Views

Tags:

Living Screen 4.00/5 (3 votes)

Robotic fabrication of algae based gels

The debate linked to a more responsive architecture, connected to nature, has been growing since the 1960s. Notwithstanding this fact, to this day, architecture is somewhat conservative: following the same principles with the belief in rigidity, solidity, and longevity. Bio-inspiration highlights a sensitive observation of biological processes and their transfer into novel design methodologies for the creation of innovative architectural explorations.

This research proposed to explore the possibilities of creating living systems by means of novel fabrication techniques (robotics) using algae as a biomaterial, thus raising the question of how to design with a material that lives, grows and dies.

The experiments developed were based on aerial algae, which obtains very similar properties in terms of photosynthesis comparing to aquatic algae, but does not need constant flow of water – although a certain humidity level must be maintained – in order to stay alive. Another interesting feature of algae is that when environmental conditions are adverse, algae goes into a form of hibernation until conditions are once again favorable. With this being said, aerial algae is much better suited for use in terms of maintenance. So the decision was taken to 3D print algae medium with an embedded culture, using a robotic arm fitted with a pump extruder.

To maintain the algae alive, two types of medium were tested

  • Agar agar medium
  • Methylcellulose (powder hydrogel) with sodium alginate

The first showed good algae growth rate, but some constraints were identified – such as extrusion temperature and algae insertion, which can be only done after having completed the printing of the medium. The second medium, on the contrary, forms a homogeneous mass that can be extruded at room temperature, having added the algae to the mix prior to printing. Thereby methylcellulose was chosen for further tests with a robotic arm, including tests on different printing parameters (pressure, speed, line thickness, etc), as well as deflation/ deformation tests in order to understand the behavior of the material while drying.

The final result represents the first large scale hydrogel print with the size of 1.5m x 4m. It was designed according to previous material tests. It was demonstrated that better results can be achieved by printing a pattern with one continuous line, creating so called nodes (line intersections) enhancing the structural capabilities of the screen. For the final print the pattern (approx. 1 km) was divided into equal parts in order to fit the available printing area (0.5m x 2m).

Moreover this fabrication method demonstrated some advantages when compared to a typical water pump systems that are using aquatic algae.

  • Fabrication time is faster
  • Reduction of overall system complexity (does not call for large amounts of technical detail)
  • Maintenance is relatively simple


Credits

Student
Irina Shaklova
Supervision
Marcos Cruz

Organization
IAAC: Institute for Advanced Architecture of Catalonia, 2015